How it works

What happens on a Cropite pass

From mounting the edge unit to reviewing results a week later. The decisions in the middle happen on the machine, plant by plant, in milliseconds.

Timing

One pass, start to finish

Mount and calibrate
half a day
Detect and act
<50 ms per frame (target)
Sync record
at the yard
Review results
7–14 days later

Steps

Five steps, two of them on the boom

1

Before the season · half a day

Mount and calibrate

Fit the edge unit and cameras. Calibration ties every camera pixel to a nozzle or tool position.

2

Before the pass · minutes

Load the plan

Agrona drafts the pass: crop, target weeds, product and fallback. An agronomist approves it.

3

During the pass · per frame

See

Folira detects every plant under the cameras and labels it.

4

During the pass · per plant

Act

Targis picks spray, skip or tool, and fires before the plant leaves the zone.

5

After the pass · days

Record and review

Acreon stores each action; a later pass records the outcome.

Who does what

Responsibilities on a pass

TaskCropiteGrower or operatorAgronomist
Mount and calibrateKit, guide, remote checkFits the kit or has the dealer fit it–
Pass planAgrona drafts itChooses fields and timingApproves product, rate and fallback
Detection and actionRuns on the machineDrives; can pause or switch to broadcast–
Label complianceEnforces the approved planFollows the product labelWrites the prescription
ReviewOutcome reportReads resultsAdjusts the next plan

Configuration

A pass plan is a short, reviewed file

pass-plan.yaml (example)
# Draft pass plan, as approved by the agronomist
field: north-40
crop: soybean
model_pack: soy-midwest-v0.3
targets:
  - weed.broadleaf
  - weed.grass
product: as-labelled, rate set by agronomist
min_confidence: 0.80
on_uncertain: spray   # spray | skip | stop
buffer_cm: 3
no_spray_zones: buffers.geojson
approval: required

What the plan controls

Nothing happens that is not in it

  • Which classes count as targets
  • The confidence needed before acting
  • What to do when unsure: spray, skip or stop
  • Buffer around each target
  • No-spray zones near water and field edges
  • Who approved it, and when

Outcomes

What you should be able to see after a pass

None of these are results yet. Pilots will measure them against check strips sprayed the normal way.

Design target

>90%

of weeds treated that a person would treat, measured on check strips.

Illustrative

5–30%

of the field sprayed instead of 100 %, depending on weed pressure.

Per pass

1record

per plant acted on, with location, model version and reason.

Draft plan

7–14days

until the follow-up pass records whether each action worked.

Questions

Questions about a pass

An agronomist or an engineer reads every message, not a sales queue.

Do I need connectivity in the field?

No. Detection and action run on the edge unit. Records sync when the machine is back in range.

Can the operator override it?

Yes. The cab display can pause per-plant mode and switch to broadcast at any time, and that switch is logged.

How fast can the machine go?

That depends on camera layout and crop. The design target is normal spraying speed; pilots will establish the real limit per setup.

Jump to a page or section